Sometimes, whether your air conditioning process is working properly, adding refrigerant is all that is needed to genuine the dispute. You can benefit an automotive recharge apparatus from your resident automotive store to act this.
Instructions
1. Probation your air conditioning action for leaks using a leak detection equipment. These are normally available at an Car parts store. Provided you examine any visible damage, gate your Highlander to a experienced to repair the leaks and recharge the air conditioning system with refrigerant.
2. If it is still low, open a new can of refrigerant and slowly add it to the system. Check the pressure often when you use more than one can of refrigerant.7. Close the valve on the refill hose and remove it from the Low Pressure Side connector port. Remove this cap and settle it aside. You Testament duty it next.
3. Evaluation your air conditioning transaction coercion using an automotive air conditioning energy gauge. Direct in capacity that in order to receive an accurate reading, the air conditioner in your Highlander has to be turned on the coldest setting with maximum blowing power. This makes the condenser kick on.
4. Connect the refill hose to the connector on the Low Pressure Side of the air conditioning system. The Low Pressure Side connector will be smaller than the High Pressure Side connector so the refill hose will fit properly only on the Low Pressure Side.
5. Turn the valve on the refill hose slowly To admit the refrigerant to enter the air conditioning system. Most kits require you to hold the can upright when you recharge the air conditioning system. It can take up to 15 minutes for the system to empty the can of refrigerant.
6. Recheck the pressure. Gander for the Low Vigour Side servicing Harbour. In most cases, it is centred in front of the engine of your Highlander. It has a melanoid cap.
Make sure that you replace the cap on the Low Pressure Side connector when you are finished recharging your air conditioner.
8. Leave the truck and air conditioner on for at least 10 minutes so the refrigerant can circulate.
