In most conditions, the siding on your inland is designed to mastery up hardy for many age with brief to no repairs bottom line. A severe hail Calamity, on the contrary, is one corporeality that has the viable to agency heavy damage to siding. Normally, hail that is 0.75 inches or more advantageous in immensity Testament design dents in aluminium siding. Whether your siding has been damaged by hail, and replacement siding is also expensive, you can one's darnedest to repair the dents yourself. All that's compelling to allot the siding is lifetime and a willingness to allot Everyone and every noticable dent.
Instructions
1. Place the largest dents on the siding. You needn't these days field yourself with the smaller dents, as you'll be able to repair those successive with aluminium filler or automotive putty.
2. Distinguish the centre of the largest dent on the siding. Location the centre with a fine-point marker or pencil.
3. Encompass a 1/8-inch drill bit into the drill. Wrinkle the drill bit up with the stop at the centre of the dent and drill a inadequate gap into the siding. Drill equal downreaching Sufficiently to deposit a gap into the siding. You should not drill into any of the underlying structure/supports.
4. Slip a washer onto a 1-inch, self-tapping screw. Gently turn the screw into the hole you drilled using a screwdriver. Do not turn the screw all of the way into the hole. Leave enough of the screw and washer exposed so that you can grasp it with your fingers or a pair of pliers.
5. Grasp the washer with your fingers and carefully pull until the dent pops out of the siding. If you cannot get a good grip on the washer with your fingers, use a pair of pliers to pull on the screw. Pull carefully, as you do not want to accidentally rip the screw out of the siding.
6. Brush a thin coat of paint onto the filler. The paint should, Sure, match the paint on the siding. Allow the paint to dry completely and reexamine your work. If you can still see the filler, you'll need to apply a second coat of paint.
Fill the remaining hole with aluminum filler or automotive putty, both of which can be found at most hardware stores. Use a small plastic applicator to apply the filler to the hole. Allow the filler to dry for the amount of time specified on the label.
8. Sand the filler with a fine-grit sandpaper (approximately 120-grit). Continue sanding until the filler is smooth and level with the surrounding siding.
9. Remove the screw and washer from the siding. Again, use a screwdriver to remove the screw.7.
10. Repeat this process for each of the major dents on your aluminum siding. For the smallest dents, you can simply fill them with aluminum filler, sand and paint.
