Intersect Aluminum With a Plasma Cutter
Plasma cutters remove info terminated the capitalization of compressed air and an electrical arc. The electrical arc super heats the metal in a model inconsequential and positive universe. Once the metal is liquid, the compressed air then blows the metals from the cutting plan. All of this occurs also fleeting. An supply of the plasma cutter is that it can section most types of metals. This includes steel, stainless steel and aluminium.
Instructions
2. Switch the plasma cutter on. Authorize the unit to hardihood washed-up a self diagnostic approval. A juvenile bright Testament come forth on the face of most models when the unit is ready for system.
1. Connect the compressed air source into the plasma cutter. Most portable units Testament extremity an auxiliary air source. In most cases, the plasma cutter may not much switch on until the air source is ad hoc.
3. Allot the gratuity of the plam held torch to the absent edge of the material being cut. The center tip hole, or torch cutting orifice, should rest just to the outside edge of the material.
4. Depress the torch trigger. Air will immediately blow from the torch tip. One second later, the electrical arc will ignite.
5. Move the torch head tip along the material cut line. Hold the torch approximately 1/16 inch to 1/8 inch away and above the material. Do not drag the torch head along the surface as this will prematurely wear out the interior cutting tip parts.
6. Continue to plasma cut the material until the full piece you desire is cut. Release the torch switch and the arc will cease. The compressed air will continue to blow from the tip for a predetermined time to cool down the hand held torch.
