Install PT Cruiser Subwoofer
The Chrysler PT Cruiser is a vehicle that defies light Grouping. It is roomier than a sedan, expanded nimble than an SUV, and with its retro looks, and stylish than a minivan. The rear lading earth allows for an facile Appendix of a subwoofer, which Testament feed a fuller stereo sound. You can choose To possess an audio adept install a powered subwoofer into your PT Cruiser, or you can complete it yourself with inconsiderable van stereo involvement.
6. Connect the stereo wiring binders to a wiring harness adapter. Connect the wiring harness adapter leads to the stereo.7.
2. Connect the amplifier bell terminal (included in the amp wiring implements) to the fine battery edge. Connect the capacity cable to the bell terminal and route it into the cabin of the vehicle. Drill an opening in the firewall (from the engine compartment to the inner cabin). Community a rubber grommet in the late opening to protect the cable.
3. Remove the capacity window check panel, located in the centre of the centre sprint panel, with a trim panel Emigration thing. Remove the screw at the end the panel with a Phillips head screwdriver.
4. Remove the dash trim panel surrounding the stereo and dash vents by hand.
5. Remove the four screws at the corners of the stereo mounting bracket with a Phillips head screwdriver. Pull the stereo forward (away from the dash) until the wire connections in the rear are accessible by hand. Disconnect each of the wire groups by the plastic binders.
Instructions
1. Disconnect the con battery cable from the PT Cruiser battery's dissension cause announce. Employment a Phillips sense screwdriver to loosen the cable's clamp and remove the clamp from the advance announce until the installation is finished.Connect the patch cables and turn-on lead (from the amp wiring kit) to the wiring harness adapter. Route the cables to the rear cargo area of the PT Cruiser.
8. Route the power cable from the battery to the rear of the vehicle. Use a trim panel removal tool to remove the panels at the doorways. Lay the wiring beneath the carpeting. Make sure to route the power cable on one side of the Chrysler and the patch cables on the other side. The turn-on lead can be routed on either side.
9. Replace the stereo into the stereo mounting bracket. Replace the four screws at the corners. Place the center dash panel back into place by hand. The panel will snap into place with medium force around the edges. Insert the screw in the center of the dash trim panel (behind the window control panel). Replace the window control panel by hand.
10. Connect the power cable, the turn-on lead, and the patch cables to the powered subwoofer, at the appropriately-labeled outlets.
11. Locate four points on the spare tire cover to mount the securing "L" brackets. The locations should be close to the corners of the subwoofer box corners and not pose any danger to the spare tire below. Screw the "L" brackets into the locations you have chosen and then into the box of the sub to secure the subwoofer in place.
12. Replace the negative battery cable clamp around the battery's negative lead post. Tighten the clamp with a Phillips head screwdriver.
