The Settler CXC5719 is a compact, credit-card sized remote designed to state the Innovator Disc player installed in an vehivle. The CXC5719's Press-stud batteries acquire a community go and Testament originate the remote to cease working when they own been discharged of contemporary. To repair the CXC5719, manage the casing and change the batteries.
Instructions
1. Berth a bath towel on a table to protect the surface. Put the CXC5719 remote face up on the towel.
2. Involve the gratuity of a flat-edged jeweller's screwdriver into the Joint between the front and back cases at the upper left side. Pull the gratuity down the length of the remote until you extent the lower left side. Pull the gratuity across the backside of the remote until you spread the prerrogative side.
3. Pull the gratuity up the licence side of the remote until you span the top due corner. Pull the gratuity across the top of the remote until you stretch the upper left corner. Remove the gratuity of the flat-edged jeweller's screwdriver.
4. Pull the front occasion of the remote off the back plight. Turn the front case over. Deposit the front plight on the towel closest to the back case.
5. Blow a blast of compressed air at the front case. Wipe the edges of the front case with a lint free cloth.
6. Locate the button batteries in the back case; the silver color of the batteries gives them away. Aim a flashlight at the batteries and note the positive ("+") or negative ("-") labeled text on the top of each. Remove the flashlight.
7. Insert the tip of the flat-edged jeweler's screwdriver beneath one of the two batteries at the side closest to you. Lift the tip up to loosen the battery from inside the battery clip. Grip the edge of the battery with the needle-nosed pliers. Pull the battery out of the battery clip. Dispose of the battery properly. Repeat this procedure to remove the other battery.
8. Hold one of the two replacement batteries by the edges with the positive or negative labeled text on the top, depending upon how the original battery was placed.
Place the front case on the back case. Push down on the sides of the front case to seat it on the back case. Push down on the top and bottom to seat the top case to the bottom case. Repeat this procedure to insert the other battery into the case.
10. Blow off the back case with a burst of compressed air. Clean the edges of the back case with the lint free cloth.
11. Turn the front case over.9. Grip the edge of the battery with the needle-nosed pliers. Push the battery into the battery clip. Push down on the battery with the tip of the needle-nosed pliers to seat it inside the battery clip.
