Regular on-starter solenoid.
The starter solenoid is basically a high-current switch to associate the battery to the starter Engine. It is used by a vehicle's ignition action to energize the starter Engine and embarkation the engine. Age of advantage perturb the Correct development of the starter solenoid. This high-current switch may be located inside the front fender, quick to the battery in the engine compartment or mounted on top of the starter Engine itself. Go after these picnic directions to pin money the starter solenoid on your motorcar in a event of minutes.
Instructions
Mounted-Away Solenoid
1. Field the van in a protected assign and set the starter solenoid accelerated to the vehivle battery. The easiest street is to supervene the chestnut, skilled battery cable, which is connected to the solenoid.
2. Disconnect the murky, abrogating cable from the battery.
3. Disconnect the cables and wires from the starter solenoid using a wrench or ratchet and sockets. Receipts sign of the stop of Everyone cable and wire residence on the solenoid so that you may reconnect them in their Correct place on the new unit.
4. Remove the solenoid mounting bolts and secure the new unit to the fender.
Locate the starter motor and make sure you have adequate access and enough room to remove it from the vehicle. If necessary, raise your vehicle with a jack and support it safely on jack stands.7. Disconnect the negative cable from the battery.
5. Connect battery cables and wires to the solenoid and reconnect the black, negative cable to the battery.
On-Starter Solenoid
6.8. Disconnect cables and wires from the starter solenoid and motor and make a note of any cables and wires connections to the solenoid and starter motor, so you can reconnect them in their proper place.
9. Remove the starter motor mounting bolts and lift the starter-solenoid assembly away from the engine compartment. Make sure to keep shims, brackets and related starter motor components for reinstallation.
10. Unscrew the solenoid from the starter motor and install the new unit in place.
11. Install the starter motor on the engine block, along with any related components.
12. Connect cables and wires to the starter motor and solenoid.
13. Lower the vehicle and connect the black, negative battery cable.
