Install a Douse Pump on a 2005 Pontiac Grand Prix
The Grand Prix was produced by the Pontiac subdivision of Typical Motors from 1962 to 2008, elementary as a full-sized luxury machine, following as a mid-sized mannequin. The 2005 Grand Prix has a V-6 engine that is cooled by a sample water-coolant step controlled by a doctor pump. The pump is located last the aptitude steering pulley, and you keep to catch off a hardly any belts to remove the doctor pump and install a different one.
Instructions
1. Lift the hood and prop it regulate. Community the filter pan underneath the radiator. Loosen and remove the empty plug on the backside of the radiator to bleed the coolant into the pan.
Remove the serpentine belt by placing the speck of the serpentine region item on the tensioner pulley. The tensioner pulley is in the centre of the engine and has a vast square stone in its centre. Pry the pulley counterclockwise to Proceeds the tension on the cestuses.
2. Loosen the four bolts that clinch the flood pump pulley to the saturate pump, using the socket wrench. Close not remove the bolts completely.3. Slip the band off the pulleys.
4. Remove the bolts holding the pulley to the flood pump.
5. Remove the two bolts that clinch the power steering pump to the engine. The bent steering pump has a plastic cylinder on top of it that's where the power steering fluid is added. Remove the two bolts holding the pump on. Allow it to rest on the oil filter housing just below it.
6. Remove the eight bolts that hold the water pump on. There are four large ones and four smaller ones. Pull the pump up and lift it out of the engine.
7. Remove the old water pump gasket. Scrape the gasket off with the razor blade. Be careful not to score the metal or the new pump will leak.
8. Set the new water pump and gasket in place. Tighten all eight bolts on the new pump.
9. Reinstall the power steering pump and its two bolts. Reinstall the serpentine belt using the serpentine belt tool. Replace the pulley on the water pump and tighten its bolts down.
