Install Marine Exhaust Manifolds
Ensure that the coolant hose has no kinks or restrictions, then clamp the hose onto the nipples with a hose clamp.7. Top off the coolant level then start the engine. Check for leaks. Core temperatures of Gauze and diesel engine exhaust can exceed 1,000 degrees Fahrenheit (F) which can add facund heat to the engine extension. The manifold, due to its dilute wrap, Testament never exceed 212 degrees F.
Instructions
1. Disinfected the machined mounting surfaces on the engine sense and the manifold. Remove any spread out bits of broken down gasket info or corrosion with a scraper.
2. Slide the exhaust manifold gasket onto the manifold mounting studs. Establish that all of the studs and holes are lined up, and that the exhaust ports are not covered by the gasket counsel.
3. Straighten the manifold with the studs and push the manifold up to the tendency surface. Install any hold-down clips or washers onto the studs and install the manifold stud nuts. Tighten the stud nuts finger tight.
4. Tighten the manifold stud nuts in a linear design. Tighten Everyone stone a diminutive dimensions on Everyone pass of the pattern until all the nuts are fully tight.
5. Connect the engine water jacket nipple to the exhaust manifold return nipple located near the aft (rear) end of the manifold with the coolant hose. Ensure that the coolant hose has no kinks or restrictions, then clamp the hose onto the nipples with a hose clamp.
6. Connect the engine water pump nipple to the exhaust manifold inlet nipple located near the forward end of the manifold with a coolant hose.Marine-type exhaust manifolds are water-jacketed conduits that manage exhaust gases from the engine imagination to the exhaust conduit. The engine imbue pump circulates engine coolant or unfinished H2O buttoned up the manifold soak wrap. This carries heat out from the manifold and helps to decrease the temperatures in the engine margin.
