Saturn recommends inspecting the lining on the brakes every 6,000 miles (9,600 km) and replacing the brake shoes when worn down to 3/32-inches (2.4mm). On the other hand, you extremely must modify the brake shoes during your perpetuation scheme whether you acquisition that the lining is peeling, cracking or is contaminated with brake fluid or grease. When ready to install the contemporary shoes, always dispensation one brake meeting as reference to dash off persuaded you reinstall the at variance components in their licence assign.
Instructions
Removing the Brake Shoes
1. Locate your transmission to "Impartial" and loosen the lug nuts on both rear trundle assemblies, using a lug wrench.
2. Stand the rear of your Saturn, using a floor jack, and community a jack stand under the frame, near the rear wheels.
13. Install the parking brake lever to the parking brake shoe, using the needle-nose pliers.14. Engage the parking brake cable to the parking brake lever, using the needle-nose pliers.
Disengage the lower give back spring and the upper adjuster spring from the brake shoes, using a brake spring thing. Duty on one side at a age and end the reverse brake meeting as a visual reference.
5. Depress the hold-down spring at the centre of the substantial shoe (the one pointing to the front side of the machine), using a hold-down spring part. From remain the backing plate, rotate the hold-down pin approximately 45 degrees to disengage the pin, then remove the pin and hold-down spring.
6. Pull the primary shoe off the brake meeting, In relation to the front of the vehicle, and remove the brake adjuster meeting from the top side of the shoe.
7. Remove the relevant shoe from the meeting.
8. Depress the hold-down spring at the centre of the parking brake shoe (the one pointing to the rear side of the motorcar), using the hold-down spring belongings. From persist the backing plate, rotate the hold-down pin approximately 45 degrees to disengage the pin, then remove the pin and hold-down spring.
9. Lift the parking brake shoe off the backing plate and disengage the parking brake cable from the parking brake lever attached to the parking brake shoe. Call a couple of needle-nose pliers.
10. Detach the retainer and washer holding the parking brake lever to the parking brake shoe, then remove the lever from the shoe, using the needle-nose pliers.
11. Disinfected the brake adjuster meeting and the backing plate with brake parts cleaner and swab all lining dust with lint-free towels.
Installing the New Brake Shoes
12. Lubricate (with brake grease) the brake adjuster meeting at the stop where it comes in contact with the parking brake bracket, besides as the backing plate raised contact points. Be careful not to receive any grease on the brake shoe lining.
3. Remove the rear wheels and the brake drums. Provided the brake shoes are holding the drums in dwelling, involve a brake adjusting effects on ice the access gap in the backing plate, then turn the first step trundle on the brake adjuster with the brake adjuster object to retract the shoes.4.
15. Fix the parking brake shoe in settle on the backing plate and install the hold-down spring and pin, using the hold-down spring object.
16. Place the advanced influential shoe in habitat on the backing plate.
17.Install the brake adjuster assembly as you hold the leading shoe in place.
18. Install the leading-shoe hold-down spring and pin, using the hold-down spring tool.
19. Engage the upper adjuster spring and lower return spring to the brake shoes, using the brake spring tool.
20. Replace the brake shoes on the opposite brake assembly following step 4 from the previous section through step 8 of this section.
21. Install and rotate the brake drum by hand. The drum should drag slightly against the brake shoes. If not, adjust the shoes by rotating the star wheel on the brake adjuster with the brake adjusting tool.
22. Mount the rear wheels and install the lug nuts snugly, using the lug wrench.
23. Lower the vehicle using the floor jack and tighten the lug nuts, using the lug wrench.
24. Depress the brake pedal several times to adjust the brake shoes and then set the parking brake.
