Alter Starter on S-10 Pickup
Whether that starter goes elsewhere, you won't be able to turn over the engine and that can be frustrating. In this circumstances, the project vehicle is a 2001 Chevrolet S-10 with a 4.3l V6 engine, on the contrary the operation is congruent for other vehicles extremely.
Instructions
Chevrolet's S-10 series of pickups was in Industry for another than 20 senility, and they can be establish approximately the society in all imitation styles. Cherish any vehicle, parts Testament eventually bang outside, including one that takes a plenty of abuse, the starter. Every lifetime you bang to turn the ignition, the starter engages.1. Lift up the front of the vehicle using the jack and secure it on jack stands. Fabricate certain the vehicle is secure on the jack stands before you crawl underneath it.
2. Pop the hood and disconnect the firm terminal of the battery using an open-end wrench. Then crawl underneath the machine and disconnect the wiring from the starter using an open-end wrench.
3. Unbolt the starter from the bracket that connects the starter to the telephone housing on the transmission besides as the bracket that connects the starter to the Engine using a 3/8-inch ratchet and socket. Then with one fist on the starter, unbolt the starter from the backside of the Engine using a 3/8-inch ratchet and socket, existence careful as you lower it down, as the starter is quite heavy.
4. Lift the replacement starter onto the engine and bolt it in place using the 3/8-inch ratchet and socket. Reconnect all of the brackets using a 3/8-inch ratchet and socket, also as the wiring using an open-end wrench.
5. Reconnect the positive terminal on the battery using an open-end wrench. Try to start the truck using the key in the ignition. If it grinds when it starts, disconnect the battery again and loosen the starter motor to add a shim from the starter shim kit. If it doesn't engage the motor, follow the same steps but remove one of the shims from the factory. Raise the vehicle off of the jack stands using the jack and place it back on the ground.
