Install a Wall Exhaust Fan
1. Community the fan's housing on the wall and hint enclosing the inner object of the fan housing with a marker or create a template using a lot of cardboard and the fan housing. Drill a starter gap in Everyone corner of the outline you prepared on the wall. Corner the coarse saying into one of the starter holes and incision from gap to gap until the cutting is integrated for the interior wall.
A wall exhaust fan eliminates humid air, fumes and odours, primarily in commercial facilities. These fans functioning wonders to remove humid air from laundry areas, tobacco-filled recreational rooms, fumes from machine protest shops or garages, and odours and heat from the galley. Shop online or at your resident hardware or native improvement store to compare brands, styles, features and prices.
Instructions
2. Stop on all sides of the inner duct of the housing front that Testament connect to the ductwork going to the out or generate a template for the away wall using the fan's magnitude. Situate the exhaust fan in the gap so that you can espy where the screws Testament commitment to hardihood. Speck the address of the screws by placing an refrigerate pick into the screw holes on the fan. Twist the harden pick left to condign while gently pushing incoming so that it Testament permit a speck on the interior wall.
3. Berth your drill on Everyone screw aim and drill the gap. Install the toggle bolts in each of the screw holes. Drill four holes inside the marked line so that you can locate where you'll need to line up your exterior wall template. Make an exterior wall template using the damper door housing dimensions and a piece of cardboard. Align the holes to the exterior template then trace the template with the marker.
4. Drill a starter hole in each corner of the exterior wall template. Place the saw in one of the corner holes and cut from hole to hole to make the opening for the damper door housing. Place the fan in the hole and attach the damper door housing using the fasteners provided. Turn the power off at the main circuit breaker or fuse box located in the basement or utility room. Test the hot wire (black) with a voltage tester to make sure there is no electrical current.
5. Connect the exhaust fan to the power supply feed by connecting the white wire (neutral) from the power supply feed to the white wire on the fan's motor then the black wire (hot) from the power supply to the switch or thermostat's black wire with wire nuts. Plug in the exhaust fan. Turn the power on at the main circuit breaker or fuse box to test the connections. Check the fan blades to make sure that they are spinning freely.
