Wednesday, April 8, 2015

Install Transom Mount Electric Motors

One of the inceptive pieces of Accoutrement that a fisherman should purchase to edit his Pleasure of the sport is a boat. Minor row boats are affordable and conceive distinctive Art for navigating bantam ponds and streams. Installing a battery and transom mount electric Engine Testament immensely access the Pleasure of the generation spent on the drench.


Instructions


Connect the cables to the battery by attaching the red spring clamp to the positive terminal and the black clamp to the negative terminal.4. Place the boat in the water and sit in the seat.


2. Sit in the rear seat facing forward and with your ability on the bridle grip. Adjust the position of the trolling Engine on the transom to the most comfortable operating position for you. Once this location is determined, tighten the transom clamps. It is important for these clamps to be very tight.


3. Set the deep cycle battery on the floor of the boat as far forward from the trolling motor as allowed by the length of the battery cables.1. Establish the trolling Engine clamp on the centre of the transom. Tighten the mounting clamps loosely by plam. The force knob should face the bow of the boat; the propeller should face the rear.


Adjust the depth of the trolling motor by adjusting the clamp on the shaft and allowing the motor to slide within the clamp until the motor is low enough To admit the propeller to be completely under water.


5. Turn the trolling motor from side to side with the hand control. Insure that the cables allow full side-to-side movement. If not, relocate the battery rearward to create additional slack in the cables until full turning is possible.