The 2.0L engine in your 2000 Honda CR-V requires a healthy fuel pump to establish its competency on the pathway. Nevertheless, whether the worn-out fuel pump is leaking or dropping impact, your SUV Testament hardly be able to churn absent the 146 hp it is capable of, whether at all. Restore efficacy to your CR-V by installing a fashionable fuel pump. This is a assignment you can perform Homewards with a infrequent easy tools you might already posses in your toolbox.
Instructions
Removing the Fuel Pump
1. Turn the ignition switch to the "Off" position.
2. Remove the anti battery cable using a wrench.
3. Loosen the fuel filler cap to Proceeds the energy in the receptacle.
4. Cleared the hood and fix the fuel filter on the firewall inside the engine compartment, in front of the air cleaner housing meeting.
5. Clutch the hex follower moulded into the top of the fuel filter with a back-up wrench.
6. Loosen slowly, approximately one turn, the banjo bolt holding the fuel path to the top of the fuel filter with a 12 mm box-end wrench. This Testament ease the fuel-system coercion. Instantly Disinfected any fuel dripping from the fuel line with a shop rag. After that, pull the fuel hose off the line.11. Depress the plastic tabs close on the quick-connect fitting of the other fuel line and pull the hose off the line.
8. Remove the frame embrace under the seat using a Phillips screwdriver.
9. Unfasten the fuel pump subsume on the floor using a Phillips screwdriver. Lift the cover to unplug the fuel pump electrical connector and place the cover aside.
10. Squeeze the tabs on the fuel-line spring clamp with a pair of square-nosed pliers and slide the clamp down the line. Then tighten the banjo bolt again.7. Lift the driver-side rear seat backside forward by help.
12. Unfasten the six nuts holding the fuel pump mounting plate to the fuel tank, using a ratchet, ratchet extension and 8 mm socket. Then carefully lift the fuel pump assembly off the tank.
13. Unplug the pump electrical connector from the pump assembly and remove the pump using a pair of needle-nose pliers and a flat-head screwdriver.
Installing the New Fuel Pump
14. Install the new fuel pump on the assembly along with a new strainer using the needle-nose pliers and a flat-head screwdriver.
15. Position the fuel pump assembly in the tank along with a new base gasket under the fuel pump mounting plate and fasten the six nuts using the ratchet, ratchet extension and 8 mm socket.
16. Push the corresponding fuel hose against the quick-connect fitting until the tabs snap in place. Slightly pull the hose to make sure it has locked in place.
17.Install the other fuel hose on the fuel line and secure it with the spring clamp using the square-nosed pliers.
18. Plug the fuel pump electrical connector, position the fuel pump cover in place and secure the cover using the Phillips screwdriver.
19. Install the frame cover using the Phillips screwdriver.
20. Fold the rear seat bottom back in place.
21. Tighten the fuel filler cap.
22. Attach the negative battery cable using the wrench.
