Replacing a wooden surround on a feverish tub requires careful interpretation.
The leading affair when replacing the wooden surround on an existing blistering tub is the weight involved. A burning tub and its operating Accoutrement weighs approximately 700 pounds. Depending on the Profundity and broadness of the tub, you can add another 3,000 pounds for the flood. When building the virgin frame, consider of it prize building a load-bearing wall in a commorancy: a group of the surrounding constitution relies on it for cooperate. Construct the just out frame with solid, sound lumber regardless of the wood used for the ancient frame.
Instructions
1. Expose the broken down frame.8. Swap out runners and cover the frames. Pull one of the runners out from under the tub and cut one to match its length.
Research the four corners of the frame to interpret how they are secured to Everyone other. Slip the metal cutting blade of the reciprocating adage between the corner pieces of the frame. Intersect the nails holding the corners in sync. Provided they are secured with screws, back them outside whether credible.
3. Revenue letter of the frame interpretation. Everyone frame has two horizontal pieces at the top and backside with studs that install vertically between them. Two of the existing frames Testament enjoy wood attached to them that runs underneath the tub. Title them as sides with runners. Replace these two frames last.
4. Measure and cut the first frame. Measure the width of one of the two frames with no runners and cut two pieces from the 2-by-4-by-96-inch lumber with the electric miter saw for the bottom and top of the frame. Measure the height of the frame from the ground up to the bottom side of the tub and subtract three inches to allow for the top and bottom of the frame. Cut one stud for every foot of the width, plus one extra stud, with the electric miter saw. For example, if the frame is five feet wide, then cut six studs.
5. Assemble the frame. Place the studs between the top and bottom pieces of the frame. Secure the studs on the ends of the frame first with the deck screws. Secure the remaining studs in the same manner, about 12 inches apart.
6. Replace the old with the new. Remove the old frame for which you built the replacement. Stand the new frame in place. Repeat this process for the other frame with no runners.
7. Install the last two frames. Measure and cut parts for the last two frames in the same manner as the others. Cut the nails holding the runners to the existing frames with the reciprocating saw, if necessary. Build the new frames, remove the old ones and set the new ones in place. Secure the corners with deck screws.
Fix the nails or screws holding the wooden skirt to the frame. Locate the nails with a Spike place and hammer or back gone the screws with a variable hurry drill and a Philips imagination screw gratuity.2. Decrease the nails in the corners. Put it in place and secure it to the frames. Repeat this for each runner. Cut the skirt from the 48-by-96-by-3/8-inch wood siding with a circular saw. Secure the skirt to the frames with drywall screws.
