Picture cars can be a tedious capacity, chiefly when it comes to stripping the stain from the vehicle. Happily, there are many differential methods to remove broken down whitewash from cars, and here we'll altercate a rare of them.
Instructions
Media Blasting
1. Remove all glass and rubber from the vehicle, owing to it Testament pay for damaged.
2. Lay on a protective suit, preferably one with a respirator. Depending on the media used, it can inspire express dusty and poisonous when media blasting, and you don't need to breath that thing in.
3. Choose a media. You can advantage sand, glass Ambition or yet baking soda. Everyone one has its own properties, so determine which works cool for your manipulate and invest in that media. Baking soda is bulky for dye Emigration, on the other hand not rust, and it's again bio-degradable. Sand and glass are congenial for tint and rust, however glass has extended consistent sizing, giving you besides predictable results.
4. In a well-ventilated sphere, advantage the media blasting part to remove the tint. Don't spend very yet epoch in one globe for it Testament start to heat up the panel and warp the steel. Just take your time and work the media across the body. Pull the trigger on the tool and slowly move across the body, watching the paint disappear as you go. Keep consistent and move about a foot a minute or so. Keep a solid pattern to make the process easier.
Manual Stripping
5. Remove all of the glass and rubber from the vehicle.
6. Use a DA sander to rough up the paint. Use an 80-grit sandpaper and work your way around the vehicle. 80-grit is usually strong enough to take the vehicle down to bare metal. Use sanding blocks in tighter areas to ensure that all the paint is gone.
7. Go over the vehicle again with 120-grit sandpaper. This is will stop the deep scratches that the 80-grit sandpaper put into the metal from showing up in the final paint job. You can also go over it yet again with 200-grit to receive a better finish.
Chemical Stripping
8. Remove all of the glass and rubber from the vehicle. Then put on the rubber gloves and make sure the car is in a well-ventilated area.
9. Carefully pour a small amount of aircraft stripper over the surface you want to remove the paint from. Use 200-grit sandpaper to rough up the surface before applying an epoxy primer.
Once it does, use a plastic squeegee or putty knife to push the old paint off the body.
11. Repeat as necessary. This may take a few applications to receive perfect, but once it's done, you'll have a bare-metal finish. Kleen-Strip is a great brand to use because it's simple to apply and easy to find.10. Let the stripper sit for a few minutes to work. It will cause the paint to lift and look like it has bubbles.
