The Chrysler Sebring may keep had differential incarnations, on the other hand some components, adoration the brakes, extreme essentially the corresponding. The pads on the Sebring's front brake discs essential to be changed at a maximum of 60,000 miles, maybe still sooner.
Instructions
1. Siphon brake fluid elsewhere of the master cylinder, sketch absent the fluid with a Disinfected siphon tube or turkey baster, until its reservoir is no else than half all-inclusive. The crack cylinder is located on the engine near the firewall on the Chauffeur's side, near the strut Garret. The reservoir you Testament siphon from is on top of the cylinder.
2. Hoist the front limitation of the automobile on jack stands and remove the wheels. Corner the lug nuts from the wheels onto the shove studs and tighten them lightly to care for the brake discs in apartment.
3. Disconnect the brake caliper from its mounting bracket by removing the director pins with a ratchet wrench. Hang the caliper somewhere gone from the brake CD using a big wire. Don't hang the caliper by its brake hose.
4. Grasp and remove the brake pads, followed by their shims, from inside the mounting bracket. Discard the aged pads and Disinfected the shims with brake cleaner. Lubricating the backing plates with a high-temperature grease Testament also help. Install the new brake pads with the shims.
5. Compress the caliper's pin back into its bore with a C-clamp. This will send extra fluid back into the master cylinder, which is why the siphon was needed. Install the caliper back on the mounting bracket, then lubricate and tighten the guide pins.
Seat the new brake pads on the disc by pressing on the brake pedal until it feels firm.
6. Replace the wheels on the car after changing the brakes on both sides, then lower the vehicle. Refill the master cylinder with as much fresh fluid as needed.7.
