One of the worthy matters approximately driving a Dodge Neon is how miniature it is and how hardy it handles alongside to the method. To accumulate this petty automobile handling passion it should, you bear to alternate the struts after every 60,000 miles of regular driving conditions. This extremely helps garner the manage smooth. This mode works finest for your 2000 to 2005 Dodge Neon.
Instructions
Change the Front Struts on a Neon
1. Lift the front mark of the Neon with a floor jack and back it by the frame with jack stands. Loosen and remove the nuts securing the front wheels with a tire iron and place the front wheels aside.
2. Establish the struts under the front undercarriage of the Neon. They see compatible coil springs with hardware inside and on Everyone limitation holding them to the frame by the top and the steering knuckle, which turns the trundle hub hold together and left, on the backside. Objective Everyone strut as belonging to the left or appropriate side of the front of the motorcar with a permanent marker.
3. Remove the seed halfway down the back of the strut securing the ground strap to it. Further remove the bracket holding on the anti-lock brake sensor and the brake hose. Appliance a wrench and a ratchet to unbolt the strut-to-knuckle bolts and remove the upper mounting nuts. Pull the strut elsewhere and repeat this method on the other side of the Neon.
4. Position the inexperienced strut meeting in the suspension development and affiliate the studs in the mounting bracket with the holes. Place the dial on the torque wrench to 25 foot lb and tighten Everyone upper mounting stone until you observe the wrench slip environing them. Attach the ground strap to the associated stud on the strut. Repeat Steps 4 and 5 on the other side of the front of the Neon.6. Mount the front wheels and lower the front foot of the machine.
Involve the strut-to-knuckle bolts, torque them Everyone to 40 foot lb and then add an extra quarter-turn to the bolts once you hit 40 foot lb.5. Attach the anti-lock brake sensor and brake hose bracket to the original strut meeting and torque the mounting bolt to 10 foot lb.
Chalk up the front wheels aligned by a known.
Change Rear Struts in a Neon
7. Stand the rear stop of the Neon and base it by the frame. Remove the rear spin and place them aside.
8. Supersede the brake hose to the strut and remove the bracket securing it and the anti-lock brake sensor. Remove the follower any form down the strut securing it to the stabilizer link bar. On the circle hub, remove the bolts holding the brake caliper, which grips the wheel hub and keep it from dangling with some wire. Unbolt the rotor too, which is the part the caliper grips.
9. Disconnect the strut-to-knuckle bolts and remove them. Pop the trunk and pull the carpet up to access the top of the strut assembly. Remove the upper mounting nuts and gently lower the strut out of the bottom of the car. Don't let the strut fall out, but remove it with care. Repeat Steps 2 and 3 on the other side of the car.
10. Position the new strut assembly in the suspension and torque the upper mounting nuts to 25 ft-lb. Lay the carpet over them, and shut the trunk. Attach the strut to the knuckle with the two bolts and torque them to 65 foot lb. Reinstall the rotor and the caliper and torque the mounting bolts to 16 foot lb. Attach the brackets holding the brake hose and anti-lock brake sensor and torque the bolts to 23 foot lb and 10 foot lb, respectively.
11. Mount the rear wheel and repeat Steps 4 and 5 up to this point on the other side of the Neon. Lower the car and torque the nut connecting the stabilizer link to 17 foot lb.
