Change brake pads before or near minimum thickness levels.
Deposit the jack under the front frame cross member and up thrust the machine until the front wheels are off the ground. Distance the jack stands under the frame carry on the front wheels and remove the wheels.2. While you corner the calipers off, contemplate the brake rotors for signs of Exorbitant heat buildup; ice they haven't been worn beyond their minimum thickness.
Instructions
1. Block one rear shove front and back to secure the vehicle. Turn the front lug nuts counterclockwise with the lug wrench to loosen them.In 1999, there were seven deviating models produced by the Saturn motorcar convention. These were sedans, coupes and wagons and they all came with the alike 1.9-liter four-cylinder engine. All the more though there are seven colorful models of Saturns to select from, the advance of replacing the brake pads is the equivalent for all of them. This channels entails removing the calipers and antique pads and installing broadcast pads.
Compass the brake pads on the box they came in with the metal backing facing up. Coat the metal backing plates with the anti-squeal adhesive.
3. Remove the caliper-locking pin and coerce pin by rotating them counterclockwise using the right Allen wrench. Pull the caliper out of the caliper support and hang it from the coil spring using a piece of wire.
4. Collapse the caliper piston using the brake pad spreader, a C-clamp or large Channellock pliers. Lift an edge on the caliper boot to remove any trapped air.
5. Remove the pad clips from the caliper and caliper support. Replace old clips with new ones.
6. Install new brake pads into the caliper and slide the caliper over the rotor. Clean the smooth portions of the pins and coat them with silicone grease.
7. Install the guide pin and locking pin, rotating them clockwise until finger tight. Tighten them with the Allen wrench. If you have the correct Allen wrench socket, torque these pins to 27 foot-pounds. An Allen wrench socket is a socket that has an Allen wrench, instead of a socket for driving nuts and bolts.
8. Install the front wheels and start the lug nuts by hand. Snug the lug nuts using the lug wrench. Raise the car off the stands, remove the stands and lower the car until the wheels make contact with the ground. Torque the lug nuts to 95 foot-pounds in a star pattern.
