Push the "Gift" Press-stud provided your Shade is blank.
Hyundai monitors are designed to go back the information from your machine onto a high-quality Shade. After using your overseer for a while, you may action issues with your Shade, such as Shade misalignment, a blank Shade or colour problems. Navigating a hardly any steps and performing basic preservation Testament enjoy your observer running akin original.
Instructions
Misaligned Screen
1. Provided the Shade isn't filling the exposure completely or provided the Shade's position is off, push the "Refreshment" Press-stud (located on the backside front of the recorder) to bring up the On-Screen Exhibit (OSD) aliment.
2.14. Unplug the signal cable from the "Signal Out" port on your computer. Detaching the cable will reset the connection. Plug the cable back into the jack by screwing the sides of the receptor into the threaded holes of the jack.
Bag the directional buttons to choose "V Position." Use the plus or minus buttons to move the screen up or down on the display, respectively.
5. Push the "Menu" button to exit after you're satisfied with your new screen alignment.
Blank Screen
6. Turn the monitor around so the back panel is easily accessible.
7. Inspect the power cord connection to the AC jack. Unplug the power cord from the jack, and examine the metal contacts for dirt or grime. If the contacts are dirty, clean them with a clean, dry cloth. Plug the power cord receptor securely back into the AC jack.
8. Examine the length of the cord for damage, such as cuts or tears. If the cord is damaged, replace it.
9. Unplug the power cord from the AC wall outlet (which will reset the connection), and examine the receptors for grime. Clean the receptors if necessary.
10. Plug a different device into the power outlet to confirm that the outlet is functioning properly. Unplug the electrical device, and plug the Hyundai power cord into the wall outlet, confirming a snug connection.
Color Defects
11. Turn the monitor's back panel toward you.
12. Locate the signal cable connection (to the right on the panel), and unscrew the cable from its jack. Inspect the pins for damage, such as missing or bent pins. If pins are missing or bent, repair or replace the cord. Gently reconnect the signal cable to the "Signal In" jack, and tighten the screws to secure the connection.
13. Examine the signal cable for dents or cuts. Replace the cord if it's damaged.
Application the directional buttons (located on the backside rim of the watchdog) to select "Picture" from the options under the leading OSD nourishment.3. Push the directional buttons to choose "H Position." Push the plus or minus buttons to act the Shade to the appropriate or left of the demonstration, respectively.4.
