Typical Motors, or GM, is an American automaker that produces the Chevrolet, Cadillac, Buick and GMC brands. The ignition switch in a GM-manufactured vehicle performs various functions. When turned to the "ACC" position, confident electrical devices can be accessed without starting the engine. Turning the switch to the "ON" position powers up your vehicle’s ignition course. Turning the material to begin" Testament activate the starter Engine to receive your engine running. Provided the ignition switch in your GM vehicle is laborious to turn or the interpretation is arduous to contain, you may committal a brand-new switch.
Instructions
1. Plain the hood. Disconnect the opposite ground cable from the battery by loosening the terminal clamp with an adjustable wrench and pulling the cable straight up from the battery. Push the cable aside.
2. Advantage the tilt lever and rotate the tilt-steering wrinkle to its plentiful upward position to concoct working extension. Pull the tilt lever straight gone of the steering edge so that the trim contain on the contour can be removed.
3. Push the switch into position until it locks into place. Place the key into the switch and turn the key to the "OFF" position. Test the switch’s operation by twisting it back and forth and by inserting and removing the key.
4. Situate the fundamental in the ignition switch and turn it to the "Dash" position. Pull the ebon plastic ignition switch retainer toward the dash panel. The retainer is J-shaped and is revealed after removing the steering column trim panel. Pull the ignition switch downward to remove it from the hole. Pull apart the wiring plug from the back of the switch.
5. Make sure your replacement switch matches the old one. Pay particular attention to the white plastic gear, making sure it is in the same position. Push the wiring plug from the steering column into the back of the replacement switch until it is fully seated.
6. Remove the two screws on the underside of the steering column trim panel with a Torx screwdriver, turning in a counterclockwise plan. Pull the insert straight down, then slide it forward absent from the sprint panel. Act not damage the trim panel’s alignment tabs while completing this daily grind.
7. Line up the tabs on the lower steering column cover with the slots in the upper cover. Slide the panel toward the dash panel until it is fully seated. Replace the screws on the underside of the cover. Push the tilt steering column lever back into its hole.
8. Push the negative battery cable back over the battery terminal and tighten the clamp. Close the hood.
