Remove a GM Ignition Lock Cylinder
Remove the anti battery terminal from the battery by loosening the devotee with an adjustable wrench in a counterclockwise plan and lifting the cable from the announce.2. Remove the horn pad from the steering trundle by removing the holding screws on the back of the steering rotate spokes with a Phillips head screwdriver turned in a counterclockwise course. Lift the horn pad from the steering turn and disconnect the wiring leads from the back of the pad by pulling them straight absent. The lock cylinder in your GM vehicle is located on the steering path and can be replaced in approximately one to two hours with automotive tools.
Instructions
1. Direct the hood.Popular Motors produces Chevrolet, GMC, Cadillac and Buick vehicles. GM besides produced Pontiac and Oldsmobile cars; on the other hand as of 2010 and 2004 respectively, these makes are no longer continuance imaginary. GM used corresponding parts in all of their vehicles, including the ignition lock cylinder, or ignition switch.
Allot the pad and screws aside.
3. Remove the centre aficionado that holds the steering revolve to the steering shaft by backing it away with an adjustable wrench in a counterclockwise direction. Set the nut aside.
4. Attach a universal steering wheel puller to the steering wheel by threading two bolts through the slots in each side of the puller and into the threaded holes in the steering wheel on each side of the steering shaft. (Note: The bolts only need to be tightened finger-tight.)
5. Remove the steering wheel by turning the center bolt on the steering wheel puller in a clockwise direction with an adjustable wrench until the wheel lifts off of the steering shaft. Set the wheel aside.
6. Remove the two screws holding the white plastic turn signal mechanism in place with a Phillips head screwdriver turned in a counterclockwise direction. Set the screws aside. Lift the turn signal mechanism up slightly to reveal the ignition lock retainer screw. Remove the screw by turning it counterclockwise with a Phillips head screwdriver. Pull the ignition lock cylinder straight out of the steering column.
