Locate a Toyota Corolla Fuel Pump
Coextensive many vehicles, the Toyota Corolla's fuel pump is contained within a module that is stored in the fuel vat itself. Unlike many larger vehicles, you won't own to remove the fuel receptacle itself provided you charge to change the pump. The fuel pump module is accessible from inside the motorcar itself underneath the rear seats. End greatest caution when working on any belongings of the fuel development in that of its formidable coercion.
Instructions
Accessing the Pump Module
1. Remove the motorcar's rear seat cushion by lifting it up to Proceeds the clip on Everyone side and pulling it outside.
2. Unplug the fuel pump's electrical connector to depressurize the fuel transaction, then expansive the Gauze cap on the absent. Eccentric person the engine for three to four seconds and bad eye for it to stall.
3. Disconnect the automobile's colorless battery cable.
Removing the Pump Module
4. Take off the fuel pump's access cover--it's either secured by butyl tape and needs prying off or has four screws you must remove.
5. Unplug any more electrical connectors on the pump module, then disconnect the fuel lines--release the fitting for the return line with needle-nosed pliers and slide out the retaining clip for the pressure hose.
6. Loosen the module's large screw-on ring with water pump pliers or a special tool from an auto parts store. On older models, remove the mounting screws instead.
7. Reconnect the negative battery cable.
9. Remove the fuel pump from the module's main housing. Check the condition of the strainer; replace it if it is dirty.
10. Install the new fuel pump onto the housing. Assemble the rest of the module in the reverse order of disassembly.
11. Place the module back into the fuel tank and tighten the ring or fasten the screws. Reconnect the fuel lines and electrical connectors.
12. Close the access cover to the pump and re-install the rear seats in the car. Withdraw the assembly with the fuel pump and fuel level sending unit out of the fuel tank.
