Rust is recurrently an motorcar's worst enemy. Rust can check in less then Day and night after a scratch or ding cuts finished the painted Stop to disclose the bare metal surface of the automobile. The rust the spreads under the colouring so you can't all the more behold the proportions of the damage until you note stain bubbling and flaking off. Get down repair Car object rust before it spreads and eats outside at your machine's thing panels.
Instructions
1. Allot all of the rust on your van's surface. Account a grinder to grind out all of the visible rust. Advance grinding the dye sorrounding the field of rust so that there is an globe of naked metal about 3 inches away from the outer edges of where the rust was removed.
2. Apply a thick coat of body filler directly to the area where the rust was removed. The body filler will fill small holes where the rust may have gone through the metal. Allow the filler to dry completely.
3. Sand the body filler with a long sanding block and 36-grit sand paper until the filler is smooth with the surface of the car.5. Apply four thin coats of automotive paint to cover the primer. Allow each coat to dry completely and then spray four coats of clear coat on top of the paint.
Spray the entire area, including the bare metal area, with three coats of automotive primer. Allow each coat to dry. Sand the top layer of primer with 120-grit sand paper and a long sanding block to smooth the surface.
Apply a thin coat of putty over the filler and allow it to dry. Sand the putty with 80-grit sand paper on the sanding block. Cover surrounding areas not intended to be painted with masking tape and paper.4.
