Decrease your motorcar's antenna with household tools.
For a digit of reasons, it might be higher quality To possess a shorter machine stereo antenna than the one that came with your machine. Some mankind treasure that their antennas bend hit when driving below low clearance structures, while others are aloof bothered by the appearance of a extensive antenna. With a elfin ingenuity, a machine stereo antenna can be spliced, shortened and then reattached without having even of an aftermath on the radio's reception.
Instructions
1. Exercise pliers to unscrew the immature bolt at the imitation of the antenna, and remove the antenna from the vehivle.
2.4. Place a strip of electrical tape between the claws of the nail puller. This will prevent the puller from scratching the antenna.
Field a abundance of electrical tape on both faces of the workbench vise to prevent them from scratching or bending the antenna.3. Habitat the antenna between the vise arms horizontally and tighten it securely. Effect not adoption further still effort, whereas this could crush its hollow object.
5. Place the antenna's disc-shaped tip between the nail puller's claws.
6. Use the hammer to hit the nail puller on the end opposite the antenna's tip, forcing the tip to fly off. It will pop off suddenly, so take care not to lose it. You will need to reattach it later.
7. Use a hacksaw to trim the top of the antenna to the desired length. Smooth rough edges where you sawed the antenna using sandpaper.
8. Put a small amount of strong adhesive at the center of the disc-shaped tip previously removed, and attach it to the end of the shortened antenna, making sure it is straight.
9. Allow the adhesive time to dry completely, and replace the antenna on the vehicle.
10. Tighten the bolt at the base of the antenna using the pliers to secure the unit in place.
