Remove a Starter in a 2002 Corolla
When the starter in your 2002 Toyota Corolla starts to an act signs of wear such as dragging, intermittent functioning or failure to operate, it is bout to remove the starter from the van and bench criterion it. The starter on the 2002 Corolla mounts on the side of the engine adjacent to the front of the van. You can access the starter from below the vehivle between the radiator and the engine, and you Testament charge to remove a guard very as lift the machine to receive to the mounting bolts and wiring connections.
Instructions
Locate the post terminal on the side of the starter just below the wiring harness connector. There will be a large single cable on it; this is the "B" terminal and provides power from the battery to the starter. Loosen the nut with a wrench and remove the cable and nut from the terminal.5. Loosen the retaining bolt with a wrench and remove the cable from the battery.
2. Up thrust the front of the automobile with a jack and buttress it by placing jack stands under the frame or front suspension. Generate firm you are on solid ground so the stands engage in not sink or slim while you are under the machine.
3. Remove the three bolts that secure the engine include to the backside of the motorcar with a socket and ratchet. Lower the include and slide it gone of the course of action. You should now be able to see the starter by looking up into the engine compartment between the engine and radiator.
4. Disconnect the wiring harness connector on the side of the starter just below the starter solenoid. Press the locking tab in and gently pull the connector loose from the starter then set it aside.1. Emptied the hood of your Corolla and allot the battery on the Chauffeur's side of the motorcar near the front of the engine compartment. Jewel the dissension battery cable on the battery-there is a colossal minus symbol moulded into the battery near the opposite cable and terminal so it is facile to bonanza.
Locate the two bolts that retain the starter to the bell housing. The mounting bolts insert from the bell housing side and thread into the starter. Remove both bolts with a socket and ratchet while supporting the starter motor.
6. Slide the starter motor back from the bell housing until it disengages the flywheel. Lower the starter motor down and remove it from under the car.
