Regular Motors recommends that you interchange the brake pads on the 2002 Chevy pickups every 50,000 miles. Sure, that is merely a average, as the bake pads may wear another quickly based on the driving habits of the owner. Public perpetuation of the brakes includes checking the pads for wear, inspecting the rotors for damage and worry the exact of brake fluid at the prescribed flat. Call the replacement of the brake pads as an big break to advantage the all-inclusive braking manner.
Instructions
Repeat the process (steps 6 through 12) for the remaining brake pads you need to change on the Chevy.14. Place the wheels back onto the wheel bolts. Screw on the lug nuts by hand.
Lift the hood and remove the cap from the skillful cylinder. The masterly cylinder contains the vehicle's overhaul of brake fluid and is located to the hold water of the Chevy's engine, near the firewall.
3. Remove half of the brake fluid from the reservoir to prevent the fluid from overflowing when the caliper piston is depressed in inevitable steps. Remove the fluid with a turkey baster or syringe. Dispose of the fluid--do not reuse it. Settle the cap loosely over the crackerjack cylinder container.
4. Loosen the lug nuts on the wheels related to the brake pads you Testament be changing. Turn Everyone kernel one half-turn with the lug wrench or 21 mm socket and breaker bar.
5. Accommodation the jack under the frame of the Chevy. Lift the vehicle and situate jack stands under the frame for bedding.
6. Remove the lug nuts and grip off the wheels.
7. Remove the two caliper slide bolts on the back side of the caliper. Loosen the bolts with a 13 mm socket wrench and Stop removing them by ability.
8. Lift the caliper from the caliper bracket and rest it above the brake meeting.
9. Slide the worn brake pads from the slots of the bracket. The pads Testament slide from the bracket's slots (on either side of the brake rotor) by participation. Pry the pads from the slots with a Apartment lodgings screwdriver whether they are stuck to the bracket by rust and leaked brake fluid.
10. Apply brake grease to the backs of the new brake pads. Slide the new pads into the caliper bracket slots on either side of the brake rotors.
11. Force the caliper pistons into the sides of the calipers with a C-clamp or channel-lock pliers. Place the clamp or pliers onto the pistons and the back of the caliper. Squeeze the pistons until they are flush with the inside wall of the caliper. This will force the brake fluid in the caliper back through the brake lines, into the master cylinder, as well as make room for the new brake pads.
12. Return the caliper over the brake pads and caliper bracket. Screw in the caliper bolts by hand. Tighten the bolts withe the 13 mm socket wrench.
13.1. Field the Chevy Motor lorry on a Apartment lodgings surface. Engage the parking brake and pull the hood Proceeds lever under the dashboard on the Chauffeur's side of the Motor lorry.2.
15. Lift the Chevy with the jack and remove the jack stands. Lower the truck back to the ground.
16. Tighten the lug nuts with the lug wrench or 21 mm socket and breaker bar. Return to the engine compartment.
17.Lift the master cylinder cap and fill the reservoir with brake fluid. Replace the cap and close the Chevy's hood.
