Monday, May 4, 2015

Replace Loudspeakers Inside A Vehicle Door

Van door speakers are either factory-installed or aftermarket additions. You sometimes must to change one of these, and it's a repair the do-it-yourself handyperson should be able to perform in a short margin of bout with a minimum of tools.


Instructions


1. Drive whether the speaker is virgin Accoutrement or an aftermarket installation. Generally, aftermarket speakers Testament be held in the door by a speaker grille that protrudes from the door, and may admit screws visible.


2. Remove any screws on the border of the speaker grille. Provided there are no visible screws, nevertheless the grille protrudes from the door panel, gently pull on the path of the grille to remove it. Don't beef it whether it does not remove without pulling the door panel with it. This Testament be held on either by a centre screw, a screw in the bezel, a lock telephone on the back of the holder, or a lock tab on the bezel.6. Remove any screws holding the armrest to the door.



Remove the window Eccentric person grip from the door. This Testament be held in district by either a screw in the centre of the grip or a lock call on the back of the holder where it enters the door.


5. Remove the door application. Skip To pace 4 provided the grille cannot be removed.3. Remove the screws you exposed by removing the grille (whether that was doable), and remove the speaker from the door.4.



7. Evaluation approximately the boundary of the door panel and remove any screws. Carefully analysis in the pile of the carpeted reduce if your door panel has one.


8. Try lifting up on the door panel to see if it slides off. Some panels use retainers that can be removed in this manner. If no movement is noted, gently pry the door panel away from the door. Use a flat tool, such as a very stiff putty knife, for this, inserting it every few inches around the door.


9. Remove the screws that were hidden behind the door panel and remove the speaker.


10. Install a new speaker.


11. Reinstall the door panel. Be sure to first line up any retainers with their hole, then push them in one at a time until all have been inserted in the door.


12. Reinstall the door handle, armrest and window handle.