Changing the headlight on a Harley-Davidson is a relatively agile and not difficult employment. This article assumes you are changing a headlight on a newer example and not a sealed bulb on an older pattern.
Instructions
1. Whether the bike has a fairing, you may commitment to remove or loosen the fairing, depending on how tightly it fits up against the headlight. Remove the chrome bell from on all sides of the headlight. This call condign snaps on and off, don't compel the phone up and down.
2. Remove the screws that grip the illumination in dwelling (generally two or three screws). Gently pull the headlight outside and down. Don't coercion the headlight in any circuit, instead gently wiggle it absent.4.
You may very contemplate adaption screws enclosing the lambent, nevertheless don't remove them. Accommodation the screws in a minor container and place aside.3.
Gently pull the three pronged plug from the extremity of the burnished once the headlight has been removed. Don't damage the plug or pull it elsewhere from the bike. Provided you can't satisfy your hands approximately the plug considering the wires are not great Sufficiently, cause your needle-nosed pliers to gently donkeywork the plug from the back of the lucent.
5. Set the old bulb aside. Put on the latex gloves, remove the new headlight from the box and wipe it clean. Ensure there is no dust or oil on the bulb or the plug.
6. Hold the new headlight up close to the housing and plug the 3-pronged connector into the back end of the bulb. Don't force or bend the connector. Again, if the wiring is not long enough for you to use your hand to plug in the connector, use needle-nosed pliers, being careful not to damage the plug.
7. After the connector is squarely plugged in, gently insert the bulb into the headlight housing. Avoid getting oil or dirt on the halogen bulb. Replace the headlight/housing screws.
8. Carefully, yet firmly, wipe the new bulb again. When you are sure the bulb is properly secured, turn the headlight on and use the adjustment screws to ensure the beam is facing forward and slightly down.
9. After adjusting the beam, replace the chrome ring around the headlight housing and wipe off any dirt or fingerprints. If you had to remove or adjust the fairing, put it back in its place and secure.
