Security tinting on machine windows is antithetic from typical tinting. While general tinting simply blocks outside harmful sun rays, security tinting prevents folk from looking into the vehicle. This tinting movie is specially designed with an opaque side that blocks away a idea from the absent while carefulness a slightly obvious side To admit Place from within the motorcar. Once you distinguish which side needs to face which succession, applying such tint is basically the identical as applying any other. This is yet a rigid growth that may hope for an assistant's facilitate.
Instructions
1. Because this is a much larger window, cutting and applying it in sections may make it easier. The razor blade Testament instantly job.
2. Disinfected all the windows by spraying them with soapy irrigate. Gallop the Apartment lodgings side of the razor blade across the windows to remove any excess dirt or residue from the fresh tint movie. Spray another coat of drench and brush it Disinfected this interval with a squeegee.
3. Assign a stage of tinting movie up against the rolled up window on the away, using the soapy water to cure it stick. Domicile it so the movie's opaque side faces away and the obvious side faces in. In this position, the movie's protective lining should be on the gone.
4. Decrease the movie to fit the window's shape. Carefully trim it along the top and side edges with a utility knife. If the door has a window frame, cut along the inner edge of the frame. If the is no window frame, cut along the window edge with the door open.
Repeat the process for the stationary side windows. This may be trickier because once you remove the lining and peel the film off the outside window, you must step into the car to apply it to the inside.8. Clean off the inside of the back window, especially along the defogging lines.
6. Prep the inside of the window with one more coat of soapy water. Carefully remove the tint film from the outside of the window and apply it to the inside. Place it in the center and then align it so it fits in place. Pull the lining completely off the bottom edge and tuck in all the bottom corners. Run the film over with the squeegee to help it bond to the window and then wipe it clean with a paper towel.
7.5. Separate the film from its protective lining, starting at the corner with the razor blade and then peeling it off. Peel it slowly while spraying more soapy water to the window, thus keeping dirt and debris from sticking to the adhesive side that is now exposed. Keep the lining attached to the film right along the bottom edge.
Spray the water and wipe it away with a scrubbing pad. Using a side-to-side motion with the pad works best.
9. Use the same cutting, peeling and applying procedure for the back window. Peel off the infant tint from the window provided it has any. There are two layers and peerless the outer layer peels easily, The side windows can be peeled with a razor blade. For the rear window, spray it with ammonia, encompass the inside of the window with plastic and go-ahead it in the sun for an age (subsume all seats and upholstery before using the ammonia).
