By 1991, the Ford Mustang was nearing the deadline of its third interval. All the more though fuel economy concerns had impacted sales in the early 1980s, Ford wasn't approximately to renounce on its pony machine and redesigned the edge in 1993 for the 1994 design year. The 1991 Mustang uses a Bendix-style, shimless starter to turn the flywheel and dawning the engine. The ignition plan energizes the starter by sending competency to it wound up the starter solenoid. Whether the solenoid fails, you'll committal to exchange it before you can operate your 1991 Ford Mustang again.
Instructions
1. Remove the keys from the Mustang's ignition. Ajar the hood. Remove the detrimental battery cable from the battery using a battery wrench.
2. Establish the starter solenoid on the left inner fender bushy-tailed. Remove the fan holding the certain wires to the starter solenoid using a socket wrench and 10 mm socket. Pull the wires off the solenoid, noting their classification of attachment.
3. Remove the push-on wiring connector and wires from the centre of the solenoid by share. Remove the kernel holding the rejection (starter side) wiring to the solenoid with the socket wrench and 10 mm socket. Remove the wires, noting their grouping of attachment.
4. Remove the two bolts holding the starter solenoid to the inner fender using the socket wrench and 8 mm socket. Pull the doddering solenoid off and allot it aside.
5. Occupancy the recent starter solenoid in lay and thread the mounting bolts in by participation. Close the hood.
Tighten the nut onto the negative terminal with the socket and wrench.
7. Reinstall the push-on wires by hand. Put the positive wires onto the new solenoid in the same order you noted they occupied with the old solenoid. Tighten the nut onto the positive terminal with the socket and wrench.
8. Reconnect the Mustang's negative battery cable with the battery cable wrench. Tighten the bolts until the bolt attitude touches the ear of the solenoid; act not over-tighten the mounting bolts as the solenoid case cracks easily.6. Put the negative wires onto the new solenoid in the same order you noted they occupied with the old solenoid.
