Maintaining an air compressor Testament snap a distant hang-up in alleviating problems with air power.
Lubricant Levels
The compressor's oil must be changed along with the system's oil filters. Old oil or a low level of oil will cause the electric motor to work harder and not bring the compressor to required speed.
When the Engine that drives the air compressor does not collect Sufficiently electricity, the Engine becomes underpowered. An air compressor than cannot rotate to a sufficient rush Testament not practise the desired quota of air. Research electrical connections periodically to lock on tightness of the connectors, and proof wires for any signs of corrosion or brittleness due to over-amperage of the Engine.
Research the air compel switch. Impact switches can stick or get worn terminal screw connectors. An improper operating compel switch directly affects the air compressor's competence to assemble pressure.
However over extent problems may occur that act on the comprehension of the compressor to occupation abundant strength. In most cases these problems can be identified and a belief applied to accession the compressor's efficiency.
Electrical
Electrical connections can act on the vigour capability of an air compressor provided the electrical connections eventually be corroded or burned.Low oil also results in greater friction, which causes excessive wear on all moving components and decreases internal air pressure.
Check the lubricant system for signs of leakage, which indicates leaking air pressure. Unloader valves, though not part of the lubricant system, control the buildup of excessive or dangerous levels of air pressure. Valves that leak will not allow the compressor to accumulate required air pressure levels.
Water and Connections
Water is collected inside all air compressor receiver and storage tanks and must be drained on a regular basis. Air compressors that run continuously may benefit from an automatic drain valve, which is located on the bottom of the storage vessels. Water filling a storage tank takes up volume needed to preserve air pressure.
Air lines that are connected to the air compressor must be inspected for any signs of leakage. Valves that are left open or leaking air lines will quickly drain the system of needed pressure. Even on large air compressor systems, a small air valve that is left open will affect pressure.
Ensure that all drive belts are in good condition and not loose. A loose drive belt will not grip the pulley of the air compressor. This loss of transmission power will reduce the efficiency of the compressor and reduce air pressure.