Installing a dewy window regulator in your Chevy Silverado's door is the impression whether the window glass won't roll up or down properly. You Testament obligation to remove the infant regulator from the door before you can install the original glass. The exact procedure can vary depending on the year of the Silverado, and you must shop for a regulator designed for your mannequin. The first glass Testament chore for the current regulator unless it is cracked or broken; convenience advanced glass provided this is the action.
Instructions
Removal
Unscrew all the mounting screws with a screwdriver and then pry off the panel with the trim stick. Lift the panel off the door and peel off the inner door's plastic shield.5. Lift up the regulator (temporarily reconnect the window controls if needed) until you can see the window glass track bolts in the door's holes, then tape the glass in place to the window frame.
If the truck uses manual windows, rub a towel behind the hand crank until it comes off its clip.
3. Detach all remaining trim caps and bezels off the door's trim panel with your trim stick; almost all of these will have mounting screws for the main panel behind them.
4.1. Disconnect the Motor lorry's antagonistic battery cable, principally whether you get a Silverado that uses ability window and locks.2. Pry the window bridle switch panel off the door trim panel using a trim stick and disconnect the electrical connector.
6. Remove the mounting bolts for the glass -- they can require a screwdriver or wrench depending on the year -- and pull off the rubber inner seal at the bottom of the window opening, if the truck has it. Remove the tape and maneuver the glass out the slot in the door.
7. Remove the fasteners for the window regulator with a wrench or screwdriver as needed and unplug the electrical connector (power windows only). Push the regulator's two guides together and withdraw the collapsed assembly through an access hole.
Installation
8. Collapse the window regulator so its two guides line up side by side. Insert the regulator into the door through the access hole, slide the guides apart so they are at their mounting holes and apply the mounting fasteners with your wrench/screwdriver.
9. Connect the electrical connector for the regulator motor, if needed.
10. Slide the window glass down into the door through the slot below the window's main opening, slide it into the channels of the window regulator and tighten the bolts securing the glass within the channels using your wrench.
11. Cover the slot in the door with its inner seal, if needed, making sure the seal connects to the pinch weld.
12. Connect the inner trim panel to the door, making sure its clips engage and applying all its screws with your screwdriver. Connect all the trim bezels to the door panel, including the screw cover caps.
13. Attach the manual window crank with its retaining clip or connect the electrical connector for the power window controls and attach the control switch plate to the door panel.
14. Reconnect the battery cable.
