Alternate the Inundate Pump in a 2004 Dodge Intrepid 2.7 Litre
2. Country a filter pan directly underneath the radiator. Establish the void plug on the backside of the radiator. Remove the extract plug and allow the coolant to drain in to the pan. You can pick up a replacement water pump from your resident Car store.
Instructions
1. Turn the engine off and allowance it for a valuable magnitude of epoch To admit the engine to completely chill down. Ajar up the hood on your Intrepid. Custom a wrench to remove the bolts on Everyone of the battery terminals. Lift both the assured and antagonistic cables elsewhere from the battery terminals.
To clinch the finest performance of the engine in your 2004 Dodge Intrepid you must see to conserve your bathe pump in the crowing working line. The aqua pump is used to aid prevent the engine from overheating by Stirring coolant from the radiator to the engine. Provided your damp pump stops working fair you should contemplate to change it as soon as imaginable. Once the radiator has been emptied, place the drain plug back in the radiator.
3. Use a wrench to remove the mounting bolts on the fan module. Lift the fan module and the bracket from the vehicle. Use a nut driver to loosen the bolt on the accessory drive belt tensioner. This will loosen the drive belt and allow you to remove it from the vehicle.
4. Remove the bolt which holds the clamp in place against the lower radiator hose. Disconnect the hose from the water pump. Use a wrench to remove the mounting bolts from the water pump. Lift the pump away from the vehicle.
5. Insert a new water pump. Fix in place with the mounting bolts. Use a torque wrench to torque the bolts to 105 inch-pounds. Attach the lower radiator hose to the water pump and fix in place with the hose clamp. Place the accessory drive belt back on the drive belt tensioner. Use the nut driver to tighten the bolt on the tensioner which will fix the drive belt tightly in place.
6. Remove the radiator cap and insert coolant back in to the radiator. Reattach the positive and negative battery cables to their respective terminals. Turn on the engine to check that the water pump works correctly.
