The ignition lock cylinder in your Honda Civic is appropriate foremost in that without it, you would gain no expedient to engage the ignition switch. The interpretation for your Honda Civic goes into the cylinder lock however over day, the lock can wear elsewhere and you Testament note it fitting harder to turn the pivotal in the lock cylinder. Whether this happens, you must transform the lock cylinder with a advanced one.
Instructions
1. Disconnect the counteractive battery terminal from the Civic's battery with a wrench.
2. Lower the steering shaft to its lowest position and remove the screws that secure the steering shaft incorporate with a screwdriver. Remove the encompass from the shaft.
3. Disconnect the wiring harness from the ignition switch located on the equitable side of the path. Remove the four screws that secure the switch to the steering shaft with a screwdriver and remove the switch.
4. Disconnect the wiring harness fro the immobilizer ascendancy unit located on the back of the lock cylinder.
5. Drill a gap in the top of the sheer bolts that secure the lock cylinder to the steering shaft with a drill bit. Remove the bolts using a bolt extractor.
6. Country the just out lock cylinder into the steering shaft and secure it using the bolts supplied with the replacement lock. These bolt acquire a hex tendency on them. Apply a wrench to secure the bolts.
7. Plug the wiring harness into the immobilizer management unit located on the back of the lock cylinder.
Reconnect the detrimental battery cable to the battery terminal with a wrench.
9. Accommodation the steering shaft embrace onto the steering shaft and secure it with the screws and screwdriver.
10.8. Secure the ignition switch onto the steering shaft with the four screws and the screwdriver. Plug the wiring harness back into the switch.
