The solenoid for a nitrous oxide action is typically mounted to the Issue Harbour that is on the valve that is on the nitrous bottle. Clearance for the nitrous solenoid is needed when determining where to mount the nitrous process. You can install many types of nitrous oxide systems on your vehicle, which accommodate the Sneeky Pete Series that is available from NOS. On the other hand before wiring the nitrous solenoid, it fundamental needs to be installed.
Instructions
Electrical Connections
5. Connect a wire to the nitrous solenoid to a ground screw on the chassis with the screwdriver. Connect another wire from the nitrous solenoid to a prong on the push button activator.Subsume the becoming site of the swivel filter into the inlet Harbour on the nitrous solenoid. Tighten the fitting on the nitrous solenoid with the wrench.
3. Attach the compression fitting onto the outlet port of the nitrous solenoid. Press down on the fitting to lock the fitting on the outlet port.
4. Attach the assembly for the solenoid to the nitrous bottle valve outlet port.
Install Solenoid
1. Use Teflon tape to the location of the man cylinder threads on the swivel filter becoming.2.6. Insert the two plugs end on the "jumper" wire to the No. 3 and No. 2 prongs for the arming toggle switch. Plug the single end of the jumper cable to the second prong for the push-button activator.
7. Attach the other end of the "jumper" wire to a ground screw on the chassis.
8. Insert the plug end of the "hot" wire with the inline fuse to the No. 1 plug on the arming toggle switch. Connect the other end of the hot wire to the positive terminal on the battery pack.
9. Attach a ground wire to the negative terminal on the battery pack and the other end of the ground wire to a metal ground.
