The front cap of a Dodge Ram.
The Dodge Ram--Dodge's workhorse pickup, declared for its horsepower, ruggedness, and perceived endowment to receive a career done--is a traditional pickup: It has body-on-frame interpretation, a conventional petrol or diesel combustion engine, and time-tested mechanical components such as a starter Engine to receive the barn door Ram's engine running. The starter, powered by the battery when you turn the primary in the ignition, engages the flywheel to locate the crankshaft in moving, starting the engine. The starter on the 2001 Dodge Ram, analogous the starter on practically any pet van, wears elsewhere over caducity of account. Replacing the starter, though, is a routine assignment that can save you means provided you cook it yourself. Changing the 2001 Ram's starter should receive peerless approximately a half-hour to replete.
Instructions
Removing the Starter
1. Accessible the hood to access the engine compartment. Disconnect the battery by removing the contravening and useful cable clamps from the battery posts.
2. Slide under the Ram and allot the starter. The starter is on the passenger side of the Motor lorry between the engine and the transmission, equal latest the oil pan. The starter is mounted to the frame by two bolts. Depending on the ground clearance of your Ram, you might be able to arrive the starter without raising the Motor lorry; provided not, you'll require to lift the front objective with a jack and country the Ram on jack stands under the frame rails on either side.
3. Disconnect the wires on the back of the starter by unscrewing the bolts on the studs. Slide the wire off the studs. There Testament be a stud for the positive wire and one for the negative wire.
Connect the negative and positive cables to the battery. Tighten the clamps by securing the retaining bolts with the 7/16-inch wrench.9. The starter is heavy.
5. Pull the old starter down and remove it from your work area.
Installing the New Starter
6. Push the starter up to the frame rail. Thread and hand-tighten the bolts to secure the starter in place. Then tighten the bolts securely with your socket wrench.
7. Push the negative and positive wire on the studs of the new starter. Tighten the bolts on the studs to secure the wires.
8.4. Unbolt the two bolts holding the starter to the frame with the socket wrench. There will be a bolt to the top and one to the bottom. Support the starter with one hand as you reach the point of removing the bolts.
Start the Ram to ensure it starts without hesitation.
