Removing the starter on your Chevy Suburban is a straightforward elbow grease. You Testament chalk up lot of interval to office underneath the vehicle, as it sits higher off the ground than a conventional vehivle. The starter is located later to the Engine, so getting to it is as manageable as crawling underneath and removing it from the backside. The starter itself is held on by two bolts and the persuaded and opposite wires. Once the starter is replaced, you Testament memo how yet quicker your Suburban cranks when turning the explanation.
Instructions
Removing the Starter
1. Disconnect the battery to isolate the electrical process. Proceeds off both the convinced and rejection terminals.
2. Set the starter, to the rear of the Engine. The ground cable will be attached to this bolt. Take the bolt and the cable loose.4.
The starter Testament be positioned on the passenger side of the vehicle. You will need to crawl under the vehicle to comprehensive this calling.3. Unscrew the bottom bolt with a socket wrench.
Remove the positive wire from the post on the starter. The wire is bolted to the terminal. You will need a socket wrench to back off the nut holding the wire on.
5. Ratchet the top bolt off with a socket wrench. Hold the starter with your spare hand, as it may work loose with the bolt.
6. Pull the starter down with your hands. The starter may be stuck in place. Tap it with a hammer to loosen it so you can bring it down.
