Adoption metric sockets on the Daewoo.
Changing a starter Engine in a 2000 Daewoo can be besides tricky. The bolt that holds the top of the starter Engine in put is covered bona fide bushy-tailed. Provided you determine not notice where To seek this bolt, changing the starter Engine Testament be immoderately frustrating. Once you carry establish the top bolt, getting the antique starter Engine absent is even a defiance as it is in all told a tight margin, and getting the tools in to receive it gone is largely exacting.
Instructions
Removing the starter motor
1. Stand the front of the vehicle off the ground with the jack and accommodation the jack stands under the chassis. Let the van down so that it is resting on the jack stands.
2. Extended the hood and remove the annulling cable from the battery. Position the denying cable so that it is not touching any metal belongings of the vehivle.
3. Slide under the motorcar and good buy the starting Engine on the exactly handwriting side of the gear box, rapid to where the impel shaft comes away to the spin. Grasp the wrench on the bolt of the bolt that holds the backside of the starter Engine to the chassis. Community the socket on the nut and, while holding the bolt in place with the wrench, turn the nut until it comes off of the bolt. Remove the bolt and move the ground cable out of the way.
4. Move to the top of the engine and find the round drum that is the brake booster. Follow the brake lines coming out of the booster down toward the engine and locate the transmission box. Feel your way forward on the engine on the transmission box until you feel a rib. On the side of the rib, you will find the second bolt that holds the starting motor in place. Remove the starter motor with the socket and ratchet.
5. Wiggle the starting motor loose and let it fall. Lift the starter motor into place and place the bolt through the hole on the chassis. Place the nut on the bolt and tighten the nut onto the bolt with the socket set and wrench set.8.
6. Place the power line on the bolt that you took off the top of the starter motor and screw the bolt into the top of the starter motor.
7. Place the bolt that holds the starting motor to the bottom of the chassis through the ground wire. Get back under the car and use the socket and ratchet to remove the power supply line from the top of the starter motor. Remove the starter motor from under the vehicle.
Replacing the starter motor.
Move to the top of the engine and bolt the top of the starter motor to the transmission box with the top screw.
9. Replace the negative battery cable and jack the car off of the jack stands. Remove the jack stands and lower the car to the ground.
