When that elderly antenna has addicted up the ghost, a automobile audio retailer can sell and install a original one. Provided you're sport, on the other hand, come next the steps below to effect it yourself.
Instructions
Removing the Original Antenna
1. Impel where you Testament advancement access to the antenna (contemplate the Tips).
2. Using a wrench or needle-nose pliers, loosen and remove the infant retaining stone on the design of the antenna mast, which houses the antenna.
3. Pull gone the antenna coaxial cable, the thick wire that connects the antenna to the interior of the vehivle.6. Unplug the coaxial cable from the space coaxial cable, a moment cable that completes the connexion from the antenna to the radio. Whether the distance from the antenna mount to the radio is short, there may be no extension coaxial.
Remove the mast.4. Achievement access to the underside of the universe where the antenna is located.5.
In that case, unplug the coaxial from the antenna lead in the back of the radio.
7. Remove the original antenna coaxial cable, noting the route the cable follows.
Installing the New Antenna
8. Read the instructions that come with the new antenna.
9. Inspect the fender area, where the antenna mast will be mounted, for rust.
10. Clean the area before installing the new antenna.
11. Plug the new antenna coaxial cable into the extension coaxial cable. (On some General Motors and Ford cars, you may need an adapter to mate the two cables. Car audio retail stores sell such adapters.)
12. Plug the new antenna's coaxial cable into the antenna lead of the radio, if there is no extension coaxial cable. Tie or tape the string you put on the extension cable to the new antenna coaxial cable. This step assures that the two cables will stay together as you route them to the antenna mount in the fender.
13. Direct the new antenna cable through the route of the original antenna cable, on up to the hole in the fender in which the mast will be mounted.
14. Insert the mast into the hole from above and screw it into the coaxial cable.
15. Replace the retainer nut at the base of the antenna mast and tighten securely.
16. Replace the panel that covers the antenna mount area.
