Pennies the influence steering pump on your Pontiac Grand Am.
Internal failure of competence steering pump components or cracks on the pump circumstances itself may advantage to issues with driving. It is nearly impossible to work a pump in such cases unless you hold specialized Accoutrement. Nevertheless, consequent these steps, you Testament be able to replace the capacity steering pump on your Pontiac Grand Am.1. Disable the air bag development whether your Pontiac Grand Am is equipped with it. Build positive the front wheels are pointing ahead to the front of the automobile and the ignition switch is in the OFF position. Remove all the fuses related to the air bag system--consult your vehicle servicing guidebook provided crucial.
The procedure applies to the 2004, 2.2, 2.4 and 3.4L engine models. Other models are companion.
Instructions
Wait a couple of minutes before you eventuate working on the capability steering manner.2. Remove the air cleaner and duct from the top of the engine compartment and the evaporative emission-EVAP-canister purge solenoid valve whether your design is equipped with one. You may appropriateness a wrench or ratchet and socket to remove the air cleaner and EVAP solenoid valve.
3. Remove the upper engine mount and the propel band whether you admit a 3.4L engine. Applicability the deserved wrench bigness or ratchet and socket. Conceive decided to flotation the engine with a floor jack once you bear removed the engine mount.
4. Lay a appropriate pan on the floor directly underneath the steering pump. Disconnect the hoses by loosening the clamps. You'll need a regular screwdriver, Phillips screwdriver or ratchet and socket. Remove the mounting bolts from the power steering pump using a wrench or ratchet and socket.
5. Lift the steering pump off the engine compartment by hand.
6. Set the new power steering pump in place by hand, install the mounting bolts and torque to 19-foot lbs (26 Nm). Install the hoses on the pump, connect the EVAP purge solenoid valve, upper air cleaner assembly and duct.
7. Torque the pump mounting bolts to 25 foot lbs. (34 Nm) if you have a 3.4L engine; install the drive belt and upper engine mount. Remove the floor jack from underneath the engine.
8. Fill the pump with power steering fluid using a funnel if necessary and bleed the system. Start the engine and turn the steering wheel completely from side to side; check the steering fluid frequently and add as needed until you purge the air from the system.
