Plasma cutters are fitting increasingly widely used, on account of their low reward of manner besides as their validity and the fineness of the intersect.
Hold the plasma torch tip at a 40-degree angle Towards the material you are cutting. Ignite the plasma arc by pressing the pre-flow air trigger. Move the plasma torch tip across the metal and look to see sparks at the metal's bottom.
Choose the type of air you intention to employ when cutting with the plasma torch gratuity: an in-house supply, a bottled supply, or an air compressor. Set the amperage on your plasma torch and make a few passes to be sure your plasma torch tip is cutting in the manner you wish. You may have to adjust the amperage up or down to accomplish desired results.
Cut with the Plasma Torch Tip
Plasma Torch Tip Applications
A plasma torch gratuity works fresh for cutting a Broad scope of metals, remarkably provided they are adequate electrical conductors. Plasma torch tips can not individual engage in stack or shape cutting, on the contrary too beveling, piercing and gouging.Prepare to Cut with the Plasma Torch Cutter
Finish your cut by angling the plasma torch tip toward the end of the metal, or bring the torch tip to a stop.Gouge with a Plasma Tip
Set the plasma torch tip at a 40-degree angle on the metal. Start the plasma torch in the same manner as for cutting. Do more than one pass when gouging the metal. Be careful not to gouge too deeply.
Pierce with a Plasma Torch Tip
Place the plasma torch tip at a 40-degree angle. Start the torch, then switch the angle of the plasma torch tip to a 90-degree angle. The plasma torch tip will pierce the metal.
