Interpretation crews appropriateness saws according to the Stihl TS 400 to chop sections outside of roads.
The Stihl TS 400 Cutquik proverb is a gasoline-powered, hand-held advantage axiom that can abbreviate wound up stone, steel, asphalt and much ductile iron. A 3.9-cubic-inch engine with a maximum spindle celerity of 5,350 rpm drives this axiom. Stihl recommends cleaning the pre-filter and auxiliary air filter prior to alpha office with the appliance or provided the saying experiences decreased engine performance. While cleaning the filters, study the leading air filter and change it as needed, as it is not a serviceable factor.
Instructions
1. Remove the plastic stone on the top of the air filter incorporate by ability, and pull the comprehend from the aphorism.
2. Turn the air filter include over and double o inside it to treasure trove the pre-filter.
3. Pull the pre-filter from the filter insert and fix it in the sun whether it is wet.
4. Blow all of the dust and debris from the pre-filter, using a compressed air source with a blower attachment.
5. Range the gap in the pre-filter with the dowel pin inside the filter include and press the pre-filter back into the filter subsume. Locate the pre-filter and the filter cover in a secure stop.
6. Remove the two screws securing the filter casing -- the plastic insert directly under where the pre-filter was -- using a Phillips screwdriver. Pull the filter casing from the maxim, exposing the leading air filter.
7. Adjust the choke to its full-closed position to prevent dirt and debris from entering the intake. Pull the main filter and look whether for dirt and debris. If the filter is full of dirt and debris, replace it with a new one.
8. Guide the filter case back onto the Stihl TS400 and tighten its screws with a Phillips screwdriver. Reinstall the pre-filter and filter cover into place on top of the filter case and tighten its nut by hand. Turn the choke to its full-open position.
Wipe the filter casing with a clean, damp cloth to remove any loose dirt and debris.
10. Reinstall the auxiliary filter into its recess on the underside of the main air filter and guide the main filter back into the filter case, with the protrusion on the auxiliary filter near the top of the filter case.
11. Grab the auxiliary air filter -- the thin air filter on the underside of the main filter. If you replaced the main air filter, you must replace this filter too. If you did not replace the main filter, blow all of the dirt and debris from the auxiliary air filter.9.
