The window glass can be individually removed, nevertheless not the regulator.
The window regulators in the Volkswagen Jetta are compressed to exchange for they are permanently built into the plastic inner door carrier. The regulator can't be separated from the carrier and replaced by itself. Whether any especial components passion the jotter window winder or influence window Engine are the complication, they can be replaced. Whether you must alternate the regulator, you'll demand to change the all-inclusive plastic carrier; consult your mechanic head.
Instructions
Removing the Trim Panel
1. Disconnect the Jetta's contravening battery cable.
2. Pry the switch bezel outside with a tiny screwdriver provided you're working on the Chauffeur's side door and it has faculty windows.5. Remove the ability window Engine by removing the fasteners at the front extremity of the carrier. You don't must to remove the carrier in this example.6.
4. Disengage the door panel from its clips by prying it off along the edges with a trim stick. Lift the door sharply upward and disconnect the inner lock rod from the door hilt and all electrical connectors.
Power Window Motor
Provided you're working on any door with guidebook windows, slide the window Eccentric person's spacer gone from the stud extreme of the apply to remove it.3. Disconnect the pull shaft obtain on a Chauffeur's door or pry off the door pull subsume on a passenger door. Remove the screws endure the detail you decent removed along with the screws at the backside column of the door trim panel.
Mount the replacement Engine in deposit at the carrier's front extremity and install the mounting bolts.
7. Reconnect the door trim panel.
Window Regulator/Winder
8. Loosen the window glass track bolts over the holes near the top of the carrier; you must to remove the rubber plugs in the carrier and exercise a socket wrench with an extension. Release the glass by separating the clamps.
9. Tape down the glass to keep it in its current position and lower the regulator all the way down. Tilt the glass' rear end upward and out of the door to remove it.
10. Unscrew the 10 bolts holding the plastic carrier in place on the door and lift it up and toward the door's inner edge. Disconnect the electrical connector for the door lock solenoid at the rear of the carrier.
11. Disconnect the window winder from the carrier by removing the fasteners that are accessible from the back.
12. Connect the replacement window winder to the carrier or the current winder to the replacement carrier.
13. Fasten the carrier back in place on the door, then raise the regulator until the bolts for the glass are accessible through the carrier holes near the top.
14. Lower the window glass into the door, starting with the front end, tilt it into position until the clamps fit a round it and tighten the bolts.
15. Connect the door's inner trim panel.
