Suzuki motorcycles bear exhaust baffles inside the tailpipe.
Motorcycle exhaust baffles edge din emission and fabricate backpressure in the exhaust action. Modifying the baffles on your Suzuki motorcycle is relatively uncomplicated, nevertheless you hog to allow for a couple of matters. Newer sport bikes according to the GSX-R750 and GSX-R1000 hog tuned exhaust systems with specially designed baffles. Modifying these can alternate the tuning and alter engine performance. Moreover, newer Suzuki baffles are incorporated into the tailpipe interpretation, unlike older types that simply slide in. You can alter Suzuki motorcycle baffles in a workshop using ability tools and lambent aptitude tools.
Instructions
Take Down
Drill additional holes in the baffle if needed.8. Stand the tailpipe on end and tap it on the workbench to clear the debris from drilling out of the baffle. Make sure all debris is cleared out before reinstalling the tailpipe on the motorcycle.
Mention to your Suzuki function album and dispose the metric tools needed to remove the baffle. On newer models, it may be de rigueur to remove the tailpipe shorten to convert the baffle. On older models, you may be directed to remove a bolt that secures the baffle in the tailpipe.
3. Postdate the procedure apt in the guidebook and remove the tailpipe divide or slide-in baffle using the convenient tools. Save any brackets or bolts. Assign the tailpipe or baffle on a workbench.
Tailpipe Baffles
4. Grip one confine the tailpipe up to a flashing and see inside the other cusp. Depending on the baffle, you may examine ideal tiny aglow or none at all. Modifying the baffle is a business of opening up areas in the baffle.
5. Chuck a 1/4-inch drill bit in an electric drill. Apply a bit time whether cold to arrive broad into the tailpipe with the drill bit.
6. Place the tailpipe on a workbench. Use a towel or rags to prevent scratching the finish. Insert the tip of the drill bit into the tailpipe and drill a 1/4-inch hole in the baffle.
7. Hold the tailpipe up to the light again. Determine the number of additional holes you want based on the purpose of the modification.1. Stadium the motorcycle on the kickstand or centre stand and permit the exhaust pipes to nippy completely.2.
Slide-In Baffles
9. Secure the outer end of the baffle in a bench vise with the baffle extending to one side. The outer end has the threaded hole where the bolt was removed to take the baffle out of the exhaust pipe.
10. Measure the length of the baffle and divide it by four. You modify a slide-in baffle by cutting off a one-quarter section at a time using a hacksaw. Mark the baffle at the one-quarter point and cut the first section off the end.
11. Reinstall the baffle in the exhaust pipe using the saved bolt and the metric tool.
Start the motorcycle and determine if the modification produced the desired result.
12. Allow the exhaust pipe to cool completely before removing the baffle for further modification. Most likely, cutting one or two quarter sections will give you the result you want. Avoid cutting too much off the baffle, or it will be useless.
