An vital cut of installing a clutch course in a instruction vehicle is the installation of the clutch fork and aligning the clutch fork. A clutch fork is a lever that the clutch linkage operates to stir the releasing bearing. They cooperate domination the shifting of the volume vehicle while the vehicle is in flow. Although clutch fork can be installed by mechanics, the mode can be costly in terms of guidebook labour and installation. It can be added cost-effective to install the clutch fork yourself, extremely as properly ally the clutch fork.
Instructions
1. Affix the clutch fork ball stud into the bellhousing by inserting the ball stud into the housing.5. Applicability a permanent marker to create a mark on the ball stud where it is protruding through the back of the bellhousing. Remove the ball stud from the bellhousing. Use a fine-tooth saw to chop the ball stud at the marked spot.
Secure the clutch fork to the ball stud.
3. Simulate the overhaul of the clutch fork to end the angle you Testament install the clutch fork at. Compass your finger in the Small pit of the clutch fork while pushing the clutch fork forward. Conserve pushing the clutch fork forward until the launch gone bearing moves forward and comes in contact with the power plate.
4. Research the angle of the clutch fork between the ball stud and pitch away bearing. Adjust the angle on an adjustable ball stud by screwing in or screwing outside the ball stud slightly. The clutch fork should be at an angle of environing 5 to 7 degrees forward.
Adjustable ball studs Testament generally chalk up an excess protruding ended the back of the bellhousing.2. Attach the toss gone bearing to the clutch fork. The frond spring clip should be underneath the Proceeds bearing collar of the clutch fork for Correct attachment. Re-insert the ball stud into the bellhousing. Secure the ball stud to the bellhousing with a locking nut.
6. Apply a small amount of grease on the head of the ball stud and reattach the ball stud to the clutch fork.
7. Install the transmission to the bellhousing by following the instructions on the transmission kit. Each transmission kit instructions will vary depending on the type of transmission kit.
8. Test the clutch fork by pushing and pulling the clutch fork. The throw-out bearing should move back and forth and be angled towards the motor.
