Always moderate the oil filter when replacing the engine oil
Changing elsewhere the oil pan on a GM vehicle is ideal straightforward. The oil pan is located at the backside of the engine. The biggest barrier when replacing the oil pan is gaining access to it. Front-wheel manage vehicles may hope for removing components to assemble space for the oil pan to come absent. Rear-wheel manage vehicles and trucks Testament keep easier access. Purchasing a scientific publication for the desired vehicle Testament arrange Emigration of the oil pan easier provided there are any obstructions.
Instructions
Removing the Oil Pan
1. Emptied the hood for access to the engine compartment. Pull the engine oil dipstick and lay it to the side.
2. Allot the engine oil pan at the backside of the engine. District a extract pan under the oil pan.
3. Unscrew the filter plug at the backside of the oil pan. Authorize the oil to filter in to the void pan. Tighten the extract plug when the oil is done draining.
4. Place the oil filter in front of the engine. Unscrew the oil filter with an oil filter wrench. Compass the elderly oil filter with the fritter engine oil.
5. Unscrew all the bolts approximately the remove pan. Unscrew them with a socket wrench. Tap the pan with a hammer to loosen it from the surface of the engine. There Testament be 14 to 20 bolts, depending on the engine amount.
6. Pull the oil pan outside from the vehicle.
Installing the New Oil Pan
7. Scrape the ancient gasket information off the backside surface of the engine with a razor scraper or putty bayonet. Effect all the gasket information is removed from the backside of the engine, as this could produce a likely oil leak in the eventual.
8. Put the modern gasket sorrounding the oil pan. Ice every bolt gap matches up with the bolt holes on the pan. To prevent the gasket from Stirring while the pan is existence mounted to the engine, run a bead of silicone RTV around the oil pan gasket and place the gasket over the silicone.
9. Bolt the pan to the bottom of the engine. Ensure all the bolts are started before tightening with a socket wrench.
10. Tighten all the bolts with a socket wrench. This will secure the oil pan.
11. Install the new oil filter by filling the filter with fresh motor oil. Lubricate the seal around the filter by spreading oil on it. Tighten the filter to the filter assembly by hand. Do not wrench-tighten the filter.
Check the oil level by cleaning the end of the dipstick with a rag and inserting it into the dipstick tube. Pull it back out and locate where the oil stops on the dipstick. If it stops below the full mark, add more oil at half-quart intervals.
12. Unscrew the oil fill cap on the valve cover of the engine and pour in the recommended amount of motor oil. Contact the local GM dealer or reference the owner's manual.13. Check the level and repeat until the dipstick reads full.
14. Start the vehicle and allow it to idle for five minutes. Turn the vehicle off and inspect the oil pan for leaks. Check the oil level to ensure the level is still at the full mark. Add more oil if necessary.
