Slide hammers come in two leading sizes, doozer and miniature, and are typically used for driving rods into the ground or removing dents from cards. The leading contrariness between the two, aside from immensity, is that the larger slide hammer requires you to proceeding the hammer downward while the leading use of the smaller slide hammer is to motion the hammer up. Provided you pursue Correct procedure and safety guidelines, the slide hammer does all the functioning for you.
Operating a Large Slide Hammer
The sizeable slide hammer is a convincing apparatus, and keeping should be taken when using it. If you use too much, however, it can rip the metal.Grip the handle firmly in one hand and the slide in the other. The slide should be at the bottom of the rod. Slam it upward into the handle, and the force will pull out the dent.
Screw the probe rod onto the slide hammer anvil. It Testament be on top of the anvil, and this probe rod immediately serves as your docent rod. It Testament not get-up-and-go into the ground. Put the slide hammer onto the ground, and slide the attendant rod into it. It should come to rest on the anvil. Lift the full unit into the upright position, and dash off confident your hands are absent from the anvil so they are not smashed whether the slide hammer manages to rise slightly and fall. Screw the loop pull cap onto the top of the attendant rod. This system is leading, and you should always paired probation that the loop pull cap is in berth.
To apply the slide hammer, place the sampler rod on the bottom over the area you want to drive it into. Then raise the slide hammer, and slam it down onto the anvil. Raise it only as high as you can comfortably reach, and never let go of the handles. You want to drive it downward with your hands, not drop it. Repeat this procedure as many times as needed to drive the sampler rod into the ground.
Operating a Small Slide Hammer
For the small, handheld slide hammer, hook or screw the end into the dent you wish to remove. Check that it is securely in place. When you first use the slide hammer, it is better to use less strength than you think you'll need. If the dent doesn't come out, you can use more strength. Always constitute undeniable the loop pull cap is screwed onto the top before using it; otherwise the hammer could fly off and hit you. Cook certain to control both hands on the handles at all times, and evaluation for any Metro utilities or lines before you dawn working to cook up decided you don't hit anything.Returns the sampler rod you hope for to operate into the ground, and screw the slide hammer anvil onto the top.
Once again, be careful not to slam it too hard or you'll rip the metal.
