Modify the Parking Brake in a Ford Explorer
A parking brake is a manageable mechanism designed for application when the valuable braking process fails. The parking brake on a Ford Explorer is cable-actuated and requires no hydraulics. A child's play pulley operation engages when the parking brake is depressed, causing a tight, all the more clamp on the rotor to cessation the motorcar from Stirring. Parking brakes normally fail whereas the parking brake cable has rusted, extended or snapped. Replacing a parking brake requires replacing the parking brake cable, a straightforward evolution any amateur mechanic Testament be able to hilt with facilitate.
Instructions
1. Stadium your Ford Explorer on a exact surface and jack up the rear location until the wheels are off the ground. Secure the van, as you Testament be working subservient it, on jack stands.
2. Loosen and remove the lug nuts holding the wheels in compass using a lug wrench or tire iron. Firmly receive the turn with both hands and pull it away from the trundle mount to expose the braking action; repeat on the contrary back circle.
3. Loosen and remove the two bolts holding the circle drum in area using an 11 mm socket and socket wrench. Firmly capture the spin drum and pull it absent from the axle plate. Whether it's identical cussed and burdensome to remove, strike it with a rubber mallet to maintenance it along. Repeat on the diametrically opposed rear spin.
4. Unfasten the parking brake shoe bolts using an fit socket and socket wrench. Loosen the emergency brake cable adjusting screw located on the brake shoe using a Philips screwdriver and pull the shoe out from the axle plate and cable.
5. Remove the emergency brake cable retaining clip using a Apartment lodgings screwdriver. Provided the retaining clip is exceptionally stubborn, strike the back of the flat screwdriver with a rubber mallet to help push the retaining clip off the brake cable.
6. Turn the emergency brake linkage spring clockwise and wiggle the brake cable free from its harnessing components. Repeat steps 4 through 6 on the opposite back wheel.
7. Reassemble the new brake cable and new brake shoes in reverse order of how you detached them. Replace the wheel drums and wheels and lower the car to the ground.9.
Follow the brake cable to the equalizing bar located beneath the middle of your car and disconnect the cable by unscrewing the nut holding the cable in place with an adjustable wrench. Detach the cable from the equalizing bar and pull it away from the underside of your car.8. Attach a new emergency brake cable to the equalizing bar in the same way you removed it.
Test the emergency brake by engaging it, putting your car in neutral and attempting to push it from the outside.
