Illustration a motorcar requires diverse steps.
Two-stage urethane distemper consists of a replica coat, which is the colour, and a clear coat, which goes on top of the representation coat for Safeguard and flash. Two-stage urethane is not a exacting whitewash to assignment with, nevertheless it does catch some skill and actuality to beget the finished dye capacity gaze expert. Delineation with two-stage urethane requires preparing the automobile's surface, mixing the whitewash and then applying both stages of the dye to the vehivle.
Instructions
Add 1 oz. of hardener to the mixture. Mix together with a stir stick. It can be poured into the spray gun cup. Mix the clear coat paint with a ratio of 4:1, which is four parts clear coat paint and one part clear coat reducer. This smooths the surface and removes any small scratches or imperfections that could harm the finished paint job. The new primer and paint won't adhere to the original clear coat, so the 320-grit sandpaper takes that coat off.
2. Place masking tape and paper over all parts of the car that won't be painted. This includes the tires, rims, trim, window glass, grill, lights, key holes and door handles.
3. Spray a thick coat of primer over the sanded surface of the car. Spray left and right, not up and down. Hold the sprayer 12 to 16 inches from the surface when spraying. Let the primer coat dry for 30 minutes.
4. Sand the dried primer using 600-grit sandpaper to smooth the primer coat. This levels the coat of primer and smooths the rough texture for the paint.
5. Mix the urethane paint and clear coat with the proper amounts of hardener and reducer. Pour the base urethane paint into a mixing cup. Add reducer to the paint to get a ratio of 2:1 of paint and reducer.1. Sand the comprehensive motorcar with 320-grit sandpaper. Sand evenly so that the entire car is dull and smooth. Mix well and keep in a closed container until needed.
6. Spray the base color coat onto the car using the same spraying techniques as with the primer. Use three to six thin coats of paint to reduce the chances of runs. Let each coat dry for five minutes before applying the next coat. Let the final coat dry for six hours.
7. Add the clear coat paint to the dried base color coat. Use the same spraying techniques as with the paint. Use three to five coats. Let each coat dry for five minutes and then let the final coat dry for a full 24 hours before handling the surface.
