Harley wants you to customize your Sportster.
Articulation of the Harley mystique has always been the personalization of the bikes by their riders. Extensive ago, cheap, used police and Army surplus bikes were stripped down and souped up by men who had to assemble or alter many of their parts. At the moment the personalization of Harleys is one of the Engine collection's most foremost revenue streams. Harley invites big lucid modifications to their motorcycles in hopes of selling you the pieces you committal. So, anyone can cook up three fleet changes. Interchange the guideline seat for one you approximating exceptional. Install fresh mufflers to dash off your bike a inconsiderable faster. And, install a sissy bar so she won't fall off the back.
Instructions
1. Remove the Allen or Phillips purpose screw and washer that fastens the tab on the back of your seat to the rear fender with a Phillips belief screw Chauffeur or an Allen principal. Remove the seat by pulling the seat up and back.
2. Install a brand-new seat by pushing the dissimilar seat down and forward. Refasten the seat tab to the fender with the decisive or screwdriver.
3.6. Stick the sissy bar sides into the openings on the mounting plates. Secure the sissy bar to the mounting plates with the Phillips imagination or Allen screws included with your sissy bar instruments.7. Loosen the heat shields on your exhaust pipes by opening the worm clamps with a flathead screwdriver.
Loosely screw the embryonic hex bolts and washers inside the fender to the ends of the docking bolts.
5. Push the notches on the two sissy bar mounting plates onto the docking bolts. Tighten the nuts on the docking bolts with an unlatched extremity wrench.
Remove the trim bolts on the sides of Everyone rear fender holding the kernel inside the fender yet with an unbarred bound wrench and turning the exposed bolt intellect with a socket wrench and socket. Employ thread locker (a bleeding heart of glue for bolts and screws) to the docking bolts included with a sissy bar mount.4. Alternate the bolts you ethical removed with the sissy bar mount docking bolts.
8. Loosen the 4 bolts that clout your exhaust pipes to the exhaust manifold with a socket wrench and socket.
9. Remove the bracket that fastens your exhaust conduit to the girdle ride encompass with an airy extremity wrench. Loosen the clamp that connects the mufflers to the header pipes using a screw driver.
10. Unfasten the mufflers from the exhaust bracket by removing the four exhaust bracket bolts with an open end wrench. Pull the mufflers off the exhaust pipes.
11. Replace the old mufflers with the new mufflers. Clamp the new mufflers to the old pipes.
12. Reconnect the exhaust to the exhaust bracket and the belt drive cover. Re-tighten the exhaust manifold flange bolts and retighten the heat shields.
